Gates - is one of the most important elements of the protected area, whether it be a country station, a cottage, an enterprise or organization. Any home without them it will seem uncomfortable and seemed unfinished. Regardless of whether where are the gates, they usually perform several key functions: provide a convenient entry and entry to the territory, while protecting against illegal intrusion or even just curious glances. On the other hand, the gate - it can be say, the business card of any home. Their appearance can tell a lot about the owner of the guests before the moment they crossed the threshold. Accordingly, the gate need to combine practicality, reliability, and beauty representativeness. In this article we'll discuss the automatic gate.
There are several basic types of them that are different design features. Automatic gates are hinged, sliding, sectional, tilt-up, guillotine, roll-up. Depending on the type, there are some features of their installation, about this and would like to tell us more. Installation of sliding gates for this type of gate large importance is the preliminary preparation of the foundation. For the manufacture of the concrete base on the inner side of the fence ripped a hole in the side to be rolled back gate. The length of this hole should be equal to half gate width and the width - about 50 cm in the pit channel set equal to the length of the well. To him weld three metal pole. Then the pit is filled with concrete, then for 8 days, he stiffens.
There are several basic types of them that are different design features. Automatic gates are hinged, sliding, sectional, tilt-up, guillotine, roll-up. Depending on the type, there are some features of their installation, about this and would like to tell us more. Installation of sliding gates for this type of gate large importance is the preliminary preparation of the foundation. For the manufacture of the concrete base on the inner side of the fence ripped a hole in the side to be rolled back gate. The length of this hole should be equal to half gate width and the width - about 50 cm in the pit channel set equal to the length of the well. To him weld three metal pole. Then the pit is filled with concrete, then for 8 days, he stiffens.
Recent Comments